How to Attach Clip-N-Go
|
Estetica Design's Clip-In Extensions should always
be clipped in starting from the bottom and working
your way to the top of the head.
Step 1: Begin by creating an horizontal part (right to left hairline) across the back of your head near the nape where you want to start clipping in the extensions. SEE DIAGRAM 2 Step 2: Once hair is parted put remaining hair in a clip away from the parted section. Step 3: While holding the extensions with the snap clip facing towards you, snap the clip open by applying outward pressure on the clip ends. |
Step 4:
To ensure the security of the clip on the hair be sure to clip the extension onto your own hair just below the part along the part line.
SEE DIAGRAM 3 Step 5: When attaching the first weft (6" piece) , attach the first clip just to the left of the center of your head and close the clip. Step 6: Release the hair you have clipped up and out of the way. Then repeat the parting process 2 or 3 inches above the first part line using the 8" weft. Note that when using the 8" weft there are 3 clips and you should begin with the center clip and attach the left and right clips thereafter. Step 7: Release the hair you have clipped up and out of the way. Then repeat the parting process 2-3 inches above the first part line using the 7" weft. Note than when using the 7" weft, there are 3 clips and you should begin with the center clip and attach the left and right clips thereafter. SEE diagram 1A Step 8: When the 2 - 6" wefts, 7" weft and 8" weft have been placed securely on head, remove the 4 1 ½" wefts from package and apply two to each side. We suggest applying one slightly above the ear and the other slightly closer to the temple. Repeat procedure on the opposite side of the head. |